MoTeC M8 - Manual (Page 3)

MoTeC Introduction 1
Introduction
Thankyou for purchasing a MoTeC Engine Management System.
This manual will help you understand the installation and calibration
requirements of your MoTeC Engine Management System.
Additional Documentation
Additional documentation is available in the form of Drawings and Tech
Notes. Please consult your local MoTeC distributor for details.
Drawing Categories
Accessories
ECUs
Looms
Ignition Modules
Combined Module & Trigger Systems
Trigger Systems
Valves
Sensors
Miscellaneous
Note that the M48 uses the M4 drawings unless there is a specific M48
drawing.
Tech Notes
Traction Control
Boost Control
Idle Speed Control
Closed Loop Lambda Control
Wide Band Lambda Sensor
Others