MoTeC M8 - Manual (Page 14)

12 MoTeC Software
E.M.P. includes the following features :
Storage of the Calibration Data on disk.
Transfer of any Calibration Data File from the PC into any ECU.
3 Dimensional Graphing of the Calibration Data.
Viewing of all sensor readings and other ECU operating parameters.
Injector, Ignition & Aux Output testing while the engine is stopped.
Extensive Help (Press the F1 key).
The E.M.P. Software is covered in more detail later in this manual.
Data Logging
Data Logging allows the ECU operational data to be recorded in a memory
chip inside the ECU, the data may then be extracted for analysis on a PC.
Data logging is extremely useful for checking mixture readings, sensor
readings, diagnostics errors and other operating information.
The items to be logged and the logging rates must be setup using the MoTeC
E.M.P. Software. This is done in the Misc Setup or Data Logging Setup
menus depending on the software version.
The logged data can be extracted from the ECU using the MoTeC
INTERPRET Software or by using the MoTeC GETLOG Software depending
on the software version.
The M4 & M48 ECUs will remember the logged data even if the ECU
power is turned off. The M8 ECU requires power to be maintained to the
ECU until the logged data has been extracted.
If the logging memory becomes full the oldest data is overwritten so that
the most recent data is always available.
The ECU must have the Logging option to perform data logging.
Data Logging Analysis
The MoTeC INTERPRET Software may be used to analyse the logged data.
The INTERPRET Software makes it easy to analyse mixture readings and
other sensor readings by presenting the data in various graphical formats.
Refer to the INTERPRET help screen for more detail.