MoTeC M8 - Manual (Page 13)

MoTeC MoTeC Software 11
chosen. The currently selected ECU type and version are shown at the top
right of the screen as shown below.
Currently Selected Type and Version Select Version Menu
To check which version of the software a particular ECU is running, start the
latest version of the E.M.P. Software. If the ECU is not the correct type or the
ECU software version does not match, then a screen will be displayed that
will show the current ECU type and version.
To change to another ECU type or version press the Esc key while in the
MoTeC Program Integrator, this will re-display the Select Version menu.
The appropriate ECU type and version may then be chosen.
The ECU software version contains an extra digit which may be ignored. For
example ECU versions 4.60, 4.61 etc are all compatible with PC software
version 4.6 (V46).
If the PC does not contain the matching version then the matching version of
the PC software must be installed onto the PC or the ECU must be upgraded
to an available version.
E.M.P Software
The MoTeC Engine Management Program (E.M.P.) is used for Calibration,
Setup and Diagnostics.