MoTeC M84 - Manual (Page 13)

MoTeC Software 11
MoTeC Software
The following software is available for the M84 ECU.
ECU Manager: Used for calibration, setup, diagnostics, output testing,
upgrading, unloading the logged data and enabling
ECU options.
i2: Used to analyse the logged data.
PC Requirements
• IBM PC compatible
• 200 MHz Pentium or faster
• Operating System: Windows XP. Windows Vista, Windows 7
Connecting a PC to the ECU
The PC must be connected to the ECU by a MoTeC UTC or CAN Cable. Note
that the ECU must be wired with the mating connector.
MoTeC CAN Cable
Connected to the
Printer Port
Installing the Software
The MoTeC Software must be installed on to the PC hard disk before it can
be used.