MoTeC M84 - Manual (Page 60)

58 ECU Manager Software MoTeC
Up / Down Adjustment
Up or Down adjustments may be made to the selected table value using the
PgUp and PgDn keys.
Fast adjustments may be made by holding the Ctrl key down while pressing
the PgUp or PgDn keys. This will increment the value by ten times the normal
amount.
If the PgUp or PgDn keys are held down the value will continue to change
until the key is released.
Locking in the New Value
When the desired adjustment has been made, the new value must be locked
in (“Set”) by pressing the Enter key. This stores the new adjustment in the
ECU’s programmable memory.
• If the cursor is moved before pressing the Enter key the value will revert
to its previous unadjusted value.
Direct Entry
The table values may also be entered directly using the number keys followed
by the Enter key.
Maths Operations
Mathematical operations may be performed on the currently selected value or
the WHOLE table or a BLOCK within a table.
To perform a maths function enter the value followed by an operation key (+, -
, *, / ). For example 2.5+ will add 2.5 to the current table value.
To apply the maths operation to the whole table type a T before pressing the
operation key. For example; 2.5T+ will add 2.5 to the whole table.
Block Operations
To perform maths on a block, mark the block by holding down the Shift key
while pressing the arrow keys, then perform the maths operation.
Quick Lambda
The Quick Lambda feature allows the Fuel - Main Table values to be
adjusted to the correct Lambda by simply pressing the Q key. This feature
uses the Wideband Lambda reading and the value from the Lambda Table to
calculate the new fuel table value. The Lambda Table may be accessed by