Appendix k: can bus wiring - single device, 5 pin connector type – MoTeC M84 User Manual
Page 80
Advertising
78 Appendices
MoTeC
Appendix K: CAN Bus Wiring - Single Device
When a single device (such as an ECU) is connected to the CAN bus the
wiring scheme shown below may be used to provide a connection point for
the MoTeC CAN cable.
If the wiring length is less than 2m (7ft) the terminating resistor is
recommended but not essential.
If other devices are connected to the CAN bus a special wiring scheme is
required. See CAN Bus Wiring Multiple Devices.
5 Pin Connector Type :
Deltron 716-0-0501 (Non
Latching)
Neutrik NC5FDL1 (Latching)
Advertising