J&M GC-31T Assembly - Manual (Page 23)

GC31
t
-1 G
rain
C
art
a
ssembly
-23-
STEP - 44
STEP - 43
Using an overhead hoist,
lift the bottom tube assem-
bly into the front left corner
of the grain cart. Lower
the bottom tube assembly
until the two corners that
are circled in the figure to
the right to go below the
tank assembly. Then raise
the lower auger back up so
that the two circled corners
can be bolted to the tank.
Attach using (25) M10 x
25 MM serrated hex head
bolts and (25) M10 serrated
hex nuts. Use a drift pin as
needed to help line up the
holes accordingly.
Using an overhead hoist, lift the bottom tube assembly using the lifting hook hole. This should help
set the appropriate angle for laying the assembly into the tank.