J&M GC-31T Assembly - Manual (Page 42)

GC31
t
-1 G
rain
C
art
a
ssembly
-42-
STEP - 82
STEP - 81
Install the baffle hinge. Use (6)
M6 x 20MM bolts, locknuts, and
washers.
Install the auger top tube
assembly and pivot pin with
M16 x 45 MM hex bolts and
nylon lock nuts extra large
washers and lock washers.
Be sure to match numbers
that are welded on the
hinge plates of both the
bottom and top tub as-
semblies (if top tube has a
7 it goes with the bottom
tube that has a 7). Now
set the adjustable auger rest.
Once it is set drill through
the remaining four holes and
use (4) M10 x 40 MM hex
head bolts, (4) washers, and
(4) nylon lock nuts.
Adjust auger rest pad.
Move the rest pad up
or down until both
circled points in the
image above are touch-
ing the rest pad. Then
drill through the shell
in the remaining holes.
Use (4) M10 x 40 hex
bolts and (4) M10 nylon
locking hex nuts.