Analog Way Di-VentiX II - Manual (Page 13)

Please ensure that the following items have been delivered with your Di-VentiX II .
1 x Di-VentiX II (DVX8044)
1 x Power supply cord
1 x MCO 8 Pin Connector
1 x RCS - Remote Control Software *
1 x User Manual (PDF Version) *
1 x Quick Start Guide *
* Download from our website: www.analogway.com
2-2. UNPACKING AND INSPECTION
2-3. MOUNTING INFORMATION
Tabletop mounting: The Di-VentiX II can be used directly on a table, the unit is equipped with
4 handy anti-slip rubber feet.
Rack mounting: The Di-VentiX II is compatible with a 19” enclosure. Please follow the instructions below to
install the device in a 19” rack.
Place the device in your rack. Attach the device to the rack by using 4 screws through the front panel holes
(screws not included).
Rear fixing is also recommended, in particular for permanent installations. The Di-VentiX II is equipped with
drill holes designed for compatibility with most rackmount braces.
Connect all of the cables of the device and attach them to the rack with the help of tie wraps.
IMPORTANT:
- The openings in the side and rear panels of the device are for cooling. Do not cover these openings and
thus avoid correct air circulation.
- Do not place a weight in excess of 2 kg (4.4 Lbs.) on the device.
- The maximum ambient operating temperature should not exceed 40°C (104°F).
- The rack and all mounted equipment in it must be correctly grounded according to national and/or local
electrical standards.
Dismantling front handles of the device will invalidate your Di-VentiX II warranty. It is strongly
advised to avoid using front handles as rests for your Di-VentiX II, they are designed for manipulation
purposes only.
If required, front handles of the device can be dismantled, but with caution.The original screws removed
must not be reintroduced to their location without handles in place. Substancial damages can occur,
including risk of electric shock from the main voltage. Only M4x12mm screws can be used. They are
supplied with the unit.
2-4. CABLE AND ADAPTOR INFORMATION
A large choice of cables and adaptors are compatible with the Di-VentiX II . To find which are to be used in
your setup, please refer to the Hardware Specifications chapter. Please contact your distributor for a list of
available cables and connectors for your Di-VentiX II .
11
!