Analog Way Di-VentiX II - Manual (Page 32)

The Di-VentiX II offers three modes to work from:
- the Mixer mode, which is the Di-VentiX II default mode,
- the Embedded Soft Edge Blending mode, which will allow you to
blend two video projection sources together to obtain one smooth
image on screen, and
- the Sync Matrix mode, which turns your Di-VentiX II into a true
8 x 2 scaled matrix.
* NOTE * : in Mixer mode, the Di-VentiX II will only let you work
on your preview screen (access to main screen is locked). The
Embedded Soft Edge Blending mode lets you access all of the
same functions as in Mixer mode, without the preview capabilities.
We recommend installing the optional video card (OPT-8044VO) for
monitoring purposes if you intend to use the Embedded Soft Edge
Blending mode often. In Sync Matrix mode, the Di-VentiX II loses
the use of layers, PIPs and effects.
To choose which mode the Di-VentiX II will work in, press the
[EXIT/MENU] button and select Mode in the menu by rotating the
corresponding knob. Then press the [SET] button to enter the Mode
sub-menu. Select which mode by rotating the corresponding knob,
and press the [SET] button to enter your choice. Press the [EXIT/
MENU] button to return to the main menu.
It is strongly recommended resetting all of the default values of your
Di-VentiX II unit before setting up your shows and events. To do
so, press the [EXIT/MENU] button and select Control in the menu
by rotating the corresponding knob. Then press the [SET] button
to enter the Control sub-menu. Select Default Values by rotating
the corresponding knob, and press the [SET] button to enter your
choice. The Di-VentiX II will revert to its factory defaults. Press the
[EXIT/MENU] button to return to the main menu. This operation will
take approximately 30 seconds.
Your machine will reboot after the reset has taken place.
4-3. WORKING WITH THE DI-VENTIX II
Operating Modes
Resetting default values
30