Analog Way Di-VentiX II - Manual (Page 82)

• SETUP DEVICE SYNC CABLE
• CHECK DEVICE SYNC OPERATION
• FOLLOW SETUP
• READY TO OPERATE
Device Sync Device Sync
Complete straight cable (8 wires)
Once all the devices booted and connected to the remote controller, you should setup a show with 3 devices (for
our example) on the same screen. If the device sync function is correctly operated, the 3 devices must show:
For accurate synchronisation, output rate must be set to «framelock» on the same reference for all the devices.
Use Genlock connector or common input as reference.
NB: make sure that other inputs that follows the reference are set «RefSync»
on the input menu (ie. 3 genlocked cameras)
--[DEVICE SYNCHRO]--
Pos: 1 Count: 3
Master
Communication OK
--[DEVICE SYNCHRO]--
Pos: 2 Count: 3
Slave
Communication OK
--[DEVICE SYNCHRO]--
Pos: 3 Count: 3
Slave
Communication OK
Extended
EDID
RefSync
Status
NB: devices will activate device sync functionnality only in multi machine mixer mode (with screen count greater than1).
Devices will not sync if:
- The device sync cable is not connected as above.
- Two or more devices have the same «screen position».
- One of the «Count» devices is missing.
- Version of all devices is not at least v5.00.
80