Analog Way Di-VentiX II - Manual (Page 33)

For the Di-VentiX II , button color codes are as follows:
- Main sources section are indicated in red .
- Preview sources section are indicated in green .
- Layer section red or green , depending on whether the selected layer is active in respectively the Main or
Preview window.
- Menu buttons are indicated in yellow .
- Unplugged or unrecognized inputs will appear in pale yellow (with autolock OFF).
- Selectable inputs will appear in pale green .
- Selecting a button with an available source or function will cause that button to blink.
- [TAKE] button reacts as follows:
If the take function is not available, the button will no light up.
If the Take function is available on non sequenced mode, button will appear pale red .
In sequenced mode, Take button blinks from pale red to pale yellow .
When take is active, it will blink rapid red .
- When a button is pressed and starts blinking rapidly, this means the Di-VentiX II is remapping the signal.
* NOTE * : buttons will blink only if the Preview button is engaged on the front panel of the Di-VentiX II.
- When pressing the [SHIFT] button then a shift enabled button (Black/Freeze, Presets 1/3...), the selected
button will blink green or red and pale yellow to indicate it is both selected (green/red blinking), and that the
shift function is active (yellow blinking).
* NOTE * : if the auto-lock function is off, sources with no input will appear pale yellow, sources with available
input will appear pale green. If auto-lock is turned on, buttons for any unavailable source will not light up or
function.
Analog Way engineers have developped a handy, user friendly way of identifying machine status on the front
panel, via the use of color codes on the buttons of the machine. All new Analog Way machines use the same
codes, for quick recognition of the status of any device of the range, at any given time.
Di-VentiX II color codes
31
1/ In the «Menu» section, press the [EXIT/MENU] button and select
Input in the menu by rotating the corresponding knob. Then press
the [SET] button to enter the Input sub-menu.
2/ In the Input menu, select your input number then select the “Type”
of input you have plugged into the Di-VentiX II by rotating the
corresponding knob (see “The Di-VentiX II Rear Panel”). Then
press the [SET] button to enter the type of input connected to the
Di-VentiX II .
3/ Press the [EXIT/MENU] button to return to the main menu.
4/ Repeat steps #1 to #3 for every source connected to your
Di-VentiX II .
Input selection settings