FlexLink XT (макс. 30 кг) Монтаж - Manual (Page 34)

34 5113235
3 Fit the screws (4 x M8) to the inside of the side
plates at the driving end
4 Loosen the screws on the inside of the side plate
at the idler end. Use the 5 mm allen key. Fit the
inner connecting plate and tighten the screws.
Use a 13 mm box wrench and 5 mm allen key.
5 Fit the remaning plates. Place the roller bridge
between the conveyors.
CAUTION! Fit one connecting plate at a time to
ensure the unit remains intact, never loosen
screws for more than one connecting plate at a
time.
6 Use a ruler to make sure that the roller bridge is
in the correct vertical position. Max distance
between ruler and roller: 1 mm.
If needed, loosen the screws for the connecting
plates again and adjust until the necessary
space is obtained.