FlexLink XT (макс. 30 кг) Монтаж - Manual (Page 71)

5113235 71
3 If F=F01
Insert the four M8 slot nuts into the T-slot on the
underside of the support frame beams.
4 Move the angle brackets on the lift and locate
unit down to their bottom position. Turn them
180°.
5 If F=F01
Pull the top plate to its fully ejected position. Fit
the lift and locate unit from above by turning it 90°
so that the angle brackets do not collide with the
support frame beams. Lover the unit until the
angle brackets are below the support frame
beams and turn it back 90°.
6 If F=F01
Fit the four M8 screws and tighten them with a
5 mm Allen key.
correct position