FlexLink XT (макс. 30 кг) Монтаж - Manual (Page 57)

5113235 57
Mounting transfer unit XTPT M1
Introduction
Mount the transfer unit on the inside of conveyor XT or
XT Compact. CAUTION! Ensure that a pallet can not fall off the
conveyor if it should pass the transfer unit by mistake.
Tools
Instruction
Allen key 3 mm
Box wrench 8 mm
Box wrench 10 mm
1 Loosen the screws (2×M5) that hold the top
cover plate. Use the 3 mm Allen key. Please note
the two loose washers under the cover plate.
2 In the plastic bag enclosed in the shipment you
find the necessary slot nuts and bolts to attach
the transfer to the conveyor. Insert the slot nuts in
the T-slots on the conveyor beam. For conveyor
XT use XCAN 6 slot nuts (the larger ones) and
M6x12 bolts, for XT Compact use XFAN 6 slot
nuts and M6x10 bolts.