FlexLink XT (макс. 30 кг) Монтаж - Manual (Page 58)

58 5113235
3 Loosen the screws that hold the side cover on
the motor side. Use the cross-slotted screw
driver. This is done to make attachment of the
transfer easy.
4 Use a cross beam, e.g. a wood plank, to get the
transfer hanging in position between the con-
veyor beams. The cross beam is fastened in one
of the slot nuts for the top cover plate. Insert the
bolts for the fastening of the transfer in the holes
(4×M6). The upper holes are for conveyor XT
Compact, the lower for conveyor XT.
5 Remove the cross beam. Make sure that the
transfer unit is hanging by its weight and in cor-
rect level. Tighten the screws. Use the 10 mm
box wrench.
6 Mount the top cover plate. Do not forget the two
washers working as distances. Use the 3 mm
Allen key. Mount the side cover plate. Use the
cross-slotted screw driver.