FlexLink XT (макс. 30 кг) Монтаж - Manual (Page 40)

40 5113235
Mounting pallet stop device XTPD D35
Introduction
The stop can be placed on the inside of the conveyor
at either the left (stop at pallet front) or right side (stop
at pallet back). If nothing else is specified the
instruction steps are valid for both XT and XT
Compact conveyors.
Tools
Instruction
Allen key 6 mm
Allen key 5 mm
1 XT conveyor:
Insert the slot nuts (2 x M8) in the conveyor T-
slot. Insert the bushings to the stop unit.
2 XT conveyor:
Fit the screws (2 x M8).
NOTE! The stop flange shall face against the
pallet direction of travel.
3 XT conveyor:
Use the 6 mm Allen key to tighten the screws.
Torque value for tightening: 25 Nm.
CAUTION! Too high torque can cause the unit to
get jamed.