FlexLink XT (макс. 30 кг) Монтаж - Manual (Page 73)

5113235 73
11 Use the 6 mm Allen key to loosen the screws on
the clamps. Press the clamps tight to the guiding
unit and tighten the screws. Torque value for
tightening: 20 Nm.
Lower the top plate again.
12 To fineadjust the height, loosen the check nut on
the cylinder rod piston using a 24 mm and a
19 mm box wrench. Turn the rod piston with one
box wrench and keep the top plate still with the
other box wrench until the correct height is
gained. Tighten the check nut.
13 Use the non-return throttle valves (A) to adjust
the speed of the pneumatic cylinder. Use a small
screwdriver.
A