Devices, Layout, Adding devices – FlexLink YOUTILIZE User Manual
Page 58: New motor, Providing production efficiency
Providing production efficiency
Page 58 of 125
Figure 72
Notice the ‘Current Controller’ setting which is important when configuration a line that contains
more than one controller.
You can see that you have two tabs at the top of the ‘FlexLink System Configuration Tool’ dialog,
Devices and Layout.
Devices
The Devices tab presents the options for adding and configuration various devices that are being
controlled by the ‘Current Controller’ (PLC). In this tab you can add Motors, Functions, and/or
Analog Sensors.
Layout
The Layout tab presents a view of the system (line) and the controllers that are included. If you
select a controller you can add Workstations, Entry Points, and/or Exit Points as applicable.
Adding Devices
New Motor
Make sure you have the correct ‘Current Controller’ selected.