FlexLink YOUTILIZE - Manual (Page 62)

Providing production efficiency
Page 62 of 125
Under ‘Properties’ enter information as described below:
• PLC Item Index: This is also known as the Tag in the PLC.
• FlexLink Identifier: Identifying name FlexLink uses to describe the Analog Sensor.
• Name: Name used to identify the item in the iMonitor Express GUI.
• Description: Field for entering a description for the device.
• Enabled: Checked by default and should remain checked.
• Controller: Populated with information relative to the ‘Current Controller’ setting.
Repeat the above steps for adding a new motor for each Analog Sensor controlled by the ‘Current
Controller’
Adding Workstations and Entry/Exit Points
Workstations and Entry/Exit Points are added in the Layout tab. Once you are in the Layout tab you
will want to make sure that you have the appropriate controller selected in the tree view.
Adding Workstations
Figure 79
Click ‘Add’ and Select ‘Work Station’