FlexLink YOUTILIZE - Manual (Page 85)

Providing production efficiency
Page 85 of 125
Drive motor servicing
In iMonitor Settings there is a tab for Drive Motor Servicing. This tab is used for entering data about
the service monitoring on each conveyor.
For each service activity the Item Serviced must be filled in. Only process points of the type Motor is
possible to choose. The Service Type describes which kind of activity that is to be executed. There
are two types of components, Chain or Slide rail. For each alternative it is also possible to choose a
replacement of the component.
Every inspection requires four measuring values to be entered. For the chain it is the actual
component values that are measured but for the Slide rail the gap is measured. The component
value for the Slide rail is calculated by the combination of the Chain value and the gap value. On the
first inspection also the limit values for each inspection point must be filled in. All values have to be
entered twice to secure correct data. At last it is possible to mark the activity with User name and
Comments. The activity is finalized by entering Save.