Flowline LI90 Commander - Manual (Page 52)

52 of 57 PRELIMINARY MANUAL 27 AUG 08
Commander LI90 Series Rev 1_3
o
Next, press the Begin Simulation soft key to proceed or the Back soft key to
return
o
Next press the YES soft key to begin the Simulation
o
Simulation mode will begin after a short count down
o
Once in Simulation mode, use the two soft keys on the left to increase and
decrease the level per your requirements
o
Check all active relays to verify operation
o
To exit from Simulation mode, press the Exit soft key in the lower right corner of
the screen