Flowline LI90 Commander - Manual (Page 9)

27 AUG 08 PRELIMINARY MANUAL 9 of 57
Rev 1_3 Commander LI90 Series
Installation
• Overview
o
The mechanical installation greatly affects the operation, safety and appearance of the
system. Information is provided to mechanically install the unit such as cut out sizes,
mounting procedures and other recommendations for the proper mechanical
installation of the unit.
• Components
o
Commander Series display
o
Terminal Strips
ƒ Power (3-pin black)
ƒ Inputs (15-pin Orange)
ƒ Outputs (15-Pin Black)
ƒ Optional Interface (5-pin Orange)
o
Mounting Clips (set of four)
ƒ Quick Start Guide
• Mounting requirements
o
Commander series can be mounted through a panel or on a DIN rail.
• Panel Mounting
o
Once the panel design has been completed using the criteria and suggestions in the
following sections, use the following steps to panel mount the LI90 series.
ƒ Remove all connectors from the unit.
ƒ Press the DIN rail clip up to make passing the unit through the cutout easier.
ƒ Make sure the gasket is installed on the LI90 series and is free from dust and
debris. Check that the corners of the gasket are secure.
ƒ Pass the unit through the panel.
ƒ Insert the each of the four (4) mounting clips into the slots in the
Commander’s case. One clip should be installed on each corner. Lightly
tighten each screw so the clip is held in place.
ƒ Tighten the screws on the clips such that the gasket is compressed against the
panel.
o
For panel mount, use the standard cutout for a ¼ DIN [3.622” (92 mm) x 3.622” (92
mm)]. Use the four mounting clips to secure the display to the panel. A mounting
clip will attach to all four sides of the display.
Not to Scale