Hach-Lange NISE sc - Manual (Page 21)

21
Section 4 Operation
4.1 How to use an sc controller
The probe can be used with all sc controllers. Become familiarized with the controller's
functions before using the probe.
4.2 Sensor setup
When the sensor is connected for the first time, the sensor serial number is displayed as
the name of the sensor. To change the sensor name.
1. Open the·MAIN MENU.
2. Select SENSOR SETUP and confirm.
3. Select the corresponding sensor and confirm.
4. Select CONFIGURE and confirm.
5. Select EDIT and confirm.
6. Edit the name and confirm to return to the CONFIGURE menu.
7. Check the sensor configuration and adjust as needed to meet requirements.
8. Go back to the MAIN MENU or the Measurement mode display.
4.3 Sensor data logger
Pro Sensor provides a data memory and event memory within the sc controller. The data
memory is used to store measurement data at preset intervals; the event memory stores
events such as configuration changes, alarms and warning conditions. Both memories
can be read in CSV format (refer to the operating instructions for the sc controller).
SENSOR STATUS
4.5 Sensor menu
The following table shows the sensor menu for the AN-ISE sc probe, AISE sc probe and
NISE sc probe. If a menu item does not apply to all three probes, its applicability is
explained in footnotes.
Footnote 1 indicates applicability to the AN-ISE sc probe. The AN-ISE sc probe is used to
determine the ammonium and nitrate concentration, as well as the potassium and chloride
concentration.
Footnote 2 indicates applicability to the AISE sc probe. The AISE sc probe is used to
determine the ammonium and potassium concentration.
Footnote 3 indicates applicability to the NISE sc probe. The NISE sc probe is used to
determine the nitrate concentration and chloride concentration.
4.4 Sensor diagnostics menu
AN-ISE sc or AISE sc or NISE sc
ERROR LIST Shows all current error messages.
WARNING LIST Shows all current warnings.