Control board setup – Controlled Products Systems Group H10NX User Manual
Page 26
VIKING TECHNICAL SUPPORT 1.800.908.0884
2 4
Initial Settings
CONTROL BOARD SETUP
“Timer”
Hold Open Timer
Automatically closes the gate after
the selected amount of time from 1-60
seconds.
Turning the dial to between “0” and
“OFF” will disable this feature, requiring
a close command to close the gate.
“Speed”
Motor Speed
Increases or decreases the speed of gate
travel.
“Overlap”
Overlap Delay
Delays the gate from opening for the
selected amount of time from 1-6
seconds.
!
Typically not used on slide gates. For
Master/Slave application, the control
board that has this feature turned on
is the master and will close first.
“ODS”
Obstruction Detection Sensor
Sets the amount of force required to trip
the inherent obstruction sensor.
See page 26 for more details about this
feature.