Controlled Products Systems Group H10NX - Manual (Page 7)

VIKING TECHNICAL SUPPORT 1.800.908.0884 5
TABLE OF CONTENTS:
PARTS DIAGRAM/PARTS LIST 2
OPERATOR REFERENCES 3
CONTROL BOARD REFERENCES 4
IMPORTANT SAFETY INFORMATION 6-12
Important Safety Instructions 6
Important Installation Instructions 7
Maintenance 8
General Safety Precautions 8-9
Operator Classification 9
Photo Beam (non-contact sensor) Installation 10
Edge Sensor (contact sensor) Installation 11
Manual Release 11
Audible Alarm Reset Installation 12
Warning Placard Installation 12
IMPORTANT INSTALLATION INFORMATION 13
Specifications 13
GATE OPERATOR INSTALLATION 14-17
Concrete Pad Option 14
Post Mounting Option 15
Operator Positioning 16-17
ELECTRICAL INSTALLATION 18-19
High Voltage Supply Option 18
Low Voltage Supply Option 19
Solar Supply Option 19
LIMITS SETUP 20-21
MASTER/SLAVE SET UP 22-23
Two Wire Communication 22
Wireless Communication Options 23
CONTROL BOARD SETUP 24-27
Initial Settings 24-25
Obstruction Detection Sensor (Primary Entrapment Protection) 26
Heater, Lock Mode................................................................................................................. 27
ACCESSORY CONNECTIONS 29-35
Re-Open Photo Beam (Vehicular Safety) 29
Radio Receiver (Typical) 30
Anti-Tail Gate, Open Commands, Guard Station
31
Viking Loop Rack 32
Guidelines for Loop Installations
33
Magnetic Lock, Lock Solenoid 34
Barrier Arm (B-12) Synchronization Option 35
TROUBLESHOOTING 36-41
LED References 36-37
LCD Display References 38-40
Solutions
41
APPENDIX A, B & C 42-45
VIKING EXPANSION PRODUCTS 46
PARTS DIAGRAM/PARTS LIST 2
OPERATOR REFERENCES 3
IMPORTANT INSTALLATION INFORMATION 13
GATE OPERATOR INSTALLATION 14-17
ELECTRICAL INSTALLATION 18-19
LIMITS SETUP 20-21
MASTER/SLAVE SET UP 22-23
CONTROL BOARD SETUP 24-27
ACCESSORY CONNECTIONS 29-35
TROUBLESHOOTING 36-41
VIKING EXPANSION PRODUCTS 46
APPENDIX A, B & C 42-45
CONTROL BOARD REFERENCES 4
IMPORTANT SAFETY INFORMATION 6-12