Controlled Products Systems Group H10NX - Manual (Page 6)

VIKING TECHNICAL SUPPORT 1.800.908.0884 4
CONTROL BOARD REFERENCES:
1. POWER HARNESS CONNECTOR
provides power to the control board.
pg 18-19
2. “OPEN LEFT” & “OPEN RIGHT”
provides power to the motor. pg 20
3. LIMIT SETUP BUTTONS
sets limit positions. pg 20-21
4. FEATURE ACTIVATION TRIM POTS
activate and set features. pg 24
5. “EPS1” CONNECTOR
available for future developments
6. “EPS2” CONNECTOR
monitors the limit positions.
7. EMI BOARD CONNECTOR
monitors the high voltage power
supply.
8. “CHECK MOTOR” Status LED
indicates motor power status. pg 36
9. “LOW BATTERY” Status LED
indicates battery power status. pg 36
10. “POWER” Status LED
control board power status. pg 18,36
11. “MAGNETIC LOCK” Status LED
status of this on-board relay. pg 34, 36
12. “MAGNETIC LOCK” Terminal Block
connect electric locks here. pg 34, 36
13. INPUT STATUS LEDS
indicates input status. pg 36-37
14. ACCESS CONTROL TERMINAL BLOCKS
accessory connections. pg 29-32, 42-44
15. “Master/Slave” Terminal Block
wired master/slave connection. pg 22
16. CONTROL BOARD MOUNTING HOLES
secures and grounds the control board.
17. “Siren” Terminal Block
Vikings UL Siren is connected here.
18. ON-BOARD 3 BUTTON STATION
controls the gate during set up.
19. “BRAKE” Terminal Block
used for solar applications & in-motion
warning devices. pg 19, 25
20. FEATURE ACTIVATION PIN HEADERS
active features by placing a jumper
onto the pin headers. pg 25
21. “DIAGNOSE” Button
allows you to navigate through the
Diagnostics LCD Display. pg 38-40
22. “DIAGNOSE” LED
informs that errors have been detected
and available on LCD Display. pg 38-40
23. LCD DIAGNOSTICS DISPLAY
provides error messages, diagnostics
and operator status information.
pg 38-40
24. EXPANSION PRODUCT CONNECTIONS
connections for additional products
from Viking Access Systems. pg 46
25. “FAIL SAFE/SECURE” Jumper
power failure option. pg 25
26. MOTOR FUSE
27. CHARGER FUSE
28. HEAT SINK
secures the control board and
dissipates heat.