Luminex 100 IS User Manual, Version 2.1 - Manual (Page 92)

100 IS S Users Manual Version 2.1 x MAP Technology
7 - 28 PN 89-00002-00-070 Rev. A
1. Click New CAL Targ. from the Maintenance tab. An Update
Cal Targets dialog box appears.
Figure 60. Update Calibration Targets Dialog Box
Enter the values listed in the kit manufacturer’s instructions or
Certificate of Analysis included with your kit into the CAL1 and
CAL2 entry fields.
2. Click OK. The database saves the updated calibration and
control values.
Note: Ensure that the correct
target values are added for
each parameter before clicking
OK. If necessary, re-enter the
information to correct any
incorrect information.