Diamond Products HCH50 - Manual (Page 15)

Operating instructions Safety instructions
HCH5011 / 001 2-1
2 Safety instructions
2.1 General
2.1.1 Target audience
This chapter describes the safety instructions that it is essential to follow
when using the Chain saw HCH5011.
All persons who work on and with the Chain saw HCH5011, have a duty
to read and understand the chapters of the Operating instructions relevant
to their particular activities.
This applies in particular to the “Safety instructions” chapter which is
mandatory for all persons and activities.
2.1.2 Observance of the safety instructions
No work must be performed on or with the Chain saw HCH5011 before the
safety instructions contained in the Operating instructions (Chapter 2) have
been read and understood. The Operating instructions are mandatory for
all work – abridged instructions should only be used in the form of
checklists.
The Chain saw HCH5011 has been inspected before being shipped and
is delivered in perfect condition. TYROLIT Hydrostress AG does not
accept any liability for damage caused by the failure to observe the
instructions and information provided in the Operating instructions. This
applies in particular to:
• Damage caused by improper use and operator error.
• Damage caused by failure to observe safety-related information in the
Operating instructions or shown on the warning signs fitted to the
machine.
• Damage caused by defective or absence of maintenance work.
Independently performed conversions and alterations may affect safety
and are not permitted.
2.1.3 Use for intended application
The intended application is described in “Chapter 1” under 1.1.2,  1-2.
2.1.4 Observance of the information on workplace safety and
danger area
The workplace and danger area are described in “Chapter 1” under
1.1.3,
 1-2.