Diamond Products HCH50 - Manual (Page 34)

Operation Operating instructions
6-2 HCH5011 / 001
Danger
Working with an incorrectly fitted chain will reduce the lifetime of
the chain and there is a danger of the chain breaking.
Use the fitting aid (chain engraving) to correctly insert the chain.
Failure to comply with this regulation may lead to serious physical
injury or death.
Danger
Noise danger
When using the Chain saw HCH5011 hearing protection must be
worn.
If this instruction is not followed irreparable hearing damage may
result.
Danger
Danger from uncontrolled movements
When the Chain saw HCH5011 is switched on, always hold it with
both hands using the handles. Thumbs and fingers must be closed
around the handles. Otherwise you may loose control of the Chain
saw HCH5011. Handles must always be clean and dry.
Failure to observe this regulation may lead to serious physical
injury, and possibly even death, and to property damage.
Danger
Danger from working at excessive chain speed or with insufficient
water feed.
This can lead to excessive wear of the chain, which in turn can
result in loss of stability and the chain breaking.
Operate the Chain saw HCH5011 at the correct speed and with
sufficient water feed.
Do not exceed a hydraulic flow of 45 l / min and 140 bar. The
working pressure of the water should be a minimum of 2.5 bar and
the flow a minimum of 7.5 l / min.
Failure to observe this regulation may lead to serious physical
injury, and possibly even death, and to property damage.