5 changing the drive wheel – Diamond Products HCH50 User Manual
Page 54
Advertising
Servicing
Operating instructions
8-6
HCH5011 / 001
8.5
Changing the drive wheel
In order to be able to change the drive wheel you must first dismantle the
bar, see “Chapter 8” 8.4.1,
8-5
To change the drive wheel you will need the wheel stop and Allen key SW
5 supplied with the tool kit.
Fig. 8-5
Changing the drive wheel
8.5.1
Dismantling the drive wheel
Proceed as follows:
• Fit the drive wheel stop (1)
• Loosen the left-hand thread Allen screw (2)
Allen key SW 5
• Remove the drive wheel and the V-seal
8.5.2
Fitting the drive wheel
• Fit the V-seal (grease the seal)
• Push drive wheel onto drive shaft
• Fit the drive wheel stop (1) and nuts (1)
• Secure the drive wheel with the Allen screw (2)
and Loctite 243
• Remove the drive wheel stop
1
2
Advertising