Diamond Products HCH50 - Manual (Page 29)

Operating instructions Controls and displays
HCH5011 / 001 4-1
4 Controls and displays
Fig. 4-1 Controls
1. Water level housing 4. Operating handle with manual starter
2. Locking cut-out 5. Couplings
3. T handle
4.1 Controls
Locking cut-out
Pressing the locking cut-out enables the ON/OFF function. This cut-out
ensures secure locking of the Chain saw HCH5011.
T handle
The T handle is used to hold and carry the Chain saw HCH5011.
Operating handle with manual starter
The operating handle with manual starter is secured by the locking cut-out
against unintentional activation. This must be operated before the Chain
saw HCH5011 can be switched on.
Couplings
The Chain saw HCH5011 is connected to the power source (power unit)
via the couplings.
4.2 Displays
Water level housing
The water level housing contains three bubble levels for alignment and
control of the direction of cut.
1
3
4
5
2