Diamond Products HCH50 - Manual (Page 50)

Servicing Operating instructions
8-2 HCH5011 / 001
8.1.2 Personnel qualifications
The Chain saw HCH5011 should not be serviced by unauthorised
persons. Personnel are only authorised where they meet the following
requirements.
• Have completed concrete expert training or professional experience.
• Have received an introduction (basic training) to the operation of the
Chain saw HCH5011 from a service engineer.
Have read and understood chapter 2 “Safety instructions”.
Warning
Danger from uncontrolled escaping of oil.
Never connect or disconnect hoses when the unit is running.
Failure to adhere to this regulation may result in cut wounds or
injury to body parts and damage to property.