Pach and Company Quantum QC Series Manual - Manual (Page 32)

Table of Contents
file:///C|/PACH%20&%20COMPANY/PACH-CO.COM/PACH-CO.COM%202012/online_manual/qc_series_manual.htm[5/19/2014 9:40:29 AM]
(door 1). The number can be changed by selecting 1-9 to trigger relay 1 (door 1). Note: by default remote access for relay
2 is set to 8, see
function code 41 . If you set relay 1 for key number 8 then you MUST change relay 2 to different key
number even though relay 2 is not used.
1. Log-in to programming
2. Enter 40 then #
3. Press 1-9 (9 is default setting) then press #
Function Code 41 DTMF Relay 2
By default the DTMF remote opening relay 2 (door 2) key number is set to 8 means pressing 8 will remotely trigger relay 2
(door 2). The number can be changed by selecting 1-9 to trigger relay 2 (door 2). Note: by default remote access for relay
1 is set to 9, see
function code 42 . If you set relay 2 for key number 9 then you MUST change relay 1 to different key
number even though relay 1 is not used.
1. Log-in to programming
2. Enter 41 then #
3. Press 1-9 (9 is default setting) then press #
Function Code 42 Relay 2 Mode
Relay 2 can be set to four different mode: 1= door control, 2= trigger simultaneously as relay 1, 3= alarm mode (see
function code 24 ), 4= turn relay 2 on/off remotely (DTMF key7/6)
1. Log-in to programming
2. Enter 42 then #
3. Enter
1= door control, 2=trigger simultaneously as relay 1, 3= alarm mode (see function code 24 ), 4= turn relay 2 on/off
remotely (DTMF key 7/6), then press #