Pach and Company Quantum QC Series Manual - Manual (Page 37)

Table of Contents
file:///C|/PACH%20&%20COMPANY/PACH-CO.COM/PACH-CO.COM%202012/online_manual/qc_series_manual.htm[5/19/2014 9:40:29 AM]
4. 2nd segment, enter the characters then press # see Chapter 3 for keypad layout
CHAPTER 5
Operations
5.1 Call from the System
1. Direct Call: press # then directory code, see function code 19
2. Scrolling: press 3 or 6 to scroll name then press # to call the selected name
5.2 Opening Door Remotely
Relay 1 (door 1), press 9
Relay 2 (door 2), press 8
5.3 Opening Door Using Access Code, Temporary Code, and Special Code
Access code Standard Operation is keyless entry code to open the door and door will be closed automatically, see
function code 06
Temporary Code is used for limited number of times, maximum 10 times then the code will be expired, see function code
33
Special Code is used to unlock hold door and then use same code to lock the door, see function code 34
Press * (display will stop scrolling) then press the 4, 5, 6, 7 or 8 digit access code as programmed on Function Code 09
5.4 Opening Door Using Card, Temporary Card, and Special Card
The Quantum QC Series has built-in card reader. The door can be access using UFOB, UCLAM or UISO.
Card Standard Operation is used to open the door and door will be closed automatically, see
function code 10
Temporary Card is used for limited of times, maximum 10 times then the card will be expired, see function code 35
Special Card is used to unlock hold door and then use same card to lock the door, see function code 36
Pach and Company UFOB, UCLAM and UISO must be used to have access to the card reader. Other
manufacturers card will not work.
Swipe the card as shown below. The card reader antenna is mounted behind the black square window.