Pach and Company Quantum QR Series QR5-QR5FF-QR5IP-QR5IPFF Manual - Manual (Page 33)

Table of Contents
file:///C|/PACH%20&%20COMPANY/PACH-CO.COM/PACH-CO.COM%202012/online_manual/qr5-qr5ip_manual.htm[5/19/2014 9:51:01 AM]
5. Enter 4-8 digit code, see digit setting on function code 09
see Chapter 3 for keypad layout
6. Present the card or fob in front of the black window, the system will register the card or fob 8-digit number printed
then press #
7. Enter 1= relay 1(door 1), 2= relay 2 (door 2) or 3= both relay then press #
8. Enter time zone 1-3 then press #
9. Enter 00 ( 24 hours ) - 20 see function code 17 then press #
10. Enter Sat ID 0-7 then press # ( enter 0 if no satellite connected to the QR5 )
11. Enter
0= no more additional time zone then press # and return to step 3 to program another temporary code
1= add additional time zone then press # and return to step 8
* = exit programming
Function Code 37 Initiate Premise Call
Call into the system from the premise (intercom mode). By default ## is used to call from the house phone to the system. If
the # key is used by the phone company, you can change to **
1. Log-in to programming
2. Enter 37 then #