Pach and Company Quantum QR Series QR5-QR5FF-QR5IP-QR5IPFF Manual - Manual (Page 34)

Table of Contents
file:///C|/PACH%20&%20COMPANY/PACH-CO.COM/PACH-CO.COM%202012/online_manual/qr5-qr5ip_manual.htm[5/19/2014 9:51:01 AM]
3. Press 0= **, 1= ## then press #
Function Code 38 System Acknowledge
The system will answer incoming outside call after the number of rings set. If the line associated with the system is
connected to fax machine, alarm panel or any answering device. Disable this function.
1. Log-in to programming
2. Enter 38 then #
3. Press
0= disable auto answer
1-9= answer in 1-9 rings
then press #
Function Code 39 Disable and Enable Remote Access
If no remote opening allow, disable it using this function code. Default setting is enabled.
1. Log-in to programming
2. Enter 39 then #
3. Press
0= disable remote access
1= enable remote access (default)
then press #
Function Code 40 DTMF Relay 1
By default the DTMF remote opening relay 1 (door 1) key number is set to 9 means pressing 9 will remotely trigger relay 1
(door 1). The number can be changed by selecting 1-9 to trigger relay 1 (door 1). Note: by default remote access for relay
2 is set to 8, see
function code 41 . If you set relay 1 for key number 8 then you MUST change relay 2 to different key
number even though relay 2 is not used.
1. Log-in to programming
2. Enter 40 then #