Pach and Company Quantum QR Series QR5-QR5FF-QR5IP-QR5IPFF Manual - Manual (Page 38)

Table of Contents
file:///C|/PACH%20&%20COMPANY/PACH-CO.COM/PACH-CO.COM%202012/online_manual/qr5-qr5ip_manual.htm[5/19/2014 9:51:01 AM]
2. Enter 46 then #
Function Code 48 PBX Enable
If the system is installed behind a Private Branch Exchange (PBX) then 9 is necessary before dialing an outside line. If
this function is enabled then the system can only be dialing an outside line, it cannot dial the extension.
1. Log-in to programming
2. Enter 48 then #
3. Enter 0= disable or 1= enable then press #
4. Enter the number to access dial tone to dial an outside line, generally 9 is the default number for most PBX system,
then press #
5. Select delay time for the PBX system to access dial tone, generally 2-3 second delay is plenty of time, then press #
Function Code 49 Edit Existing Access Code, Temporary Code and Special Code
1. Log-in to programming
2. Enter 49 then #
3. Editing an Access Code click here or
Editing a Temporary Code, click here or
Editing a Special code, then click here
Function Code 50 Erase Memory to Factory Default
Warning: This function code will erase the memory to factory default, no way to restore them unless the database has
been saved in the computer.