Pach and Company Quantum QR Series QR5-QR5FF-QR5IP-QR5IPFF Manual - Manual (Page 35)

Table of Contents
file:///C|/PACH%20&%20COMPANY/PACH-CO.COM/PACH-CO.COM%202012/online_manual/qr5-qr5ip_manual.htm[5/19/2014 9:51:01 AM]
3. Press 1-9 (9 is default setting) then press #
Function Code 41 DTMF Relay 2
By default the DTMF remote opening relay 2 (door 2) key number is set to 8 means pressing 8 will remotely trigger relay 2
(door 2). The number can be changed by selecting 1-9 to trigger relay 2 (door 2). Note: by default remote access for relay
1 is set to 9, see
function code 42 . If you set relay 2 for key number 9 then you MUST change relay 1 to different key
number even though relay 1 is not used.
1. Log-in to programming
2. Enter 41 then #
3. Press 1-9 (9 is default setting) then press #
Function Code 42 Relay 2 Mode
Relay 2 can be set to four different mode: 1= door control, 2= trigger simultaneously as relay 1, 3= alarm mode (see
function code 24 ), 4= turn relay 2 on/off remotely (DTMF key7/6)
1. Log-in to programming
2. Enter 42 then #
3. Enter
1= door control, 2=trigger simultaneously as relay 1, 3= alarm mode (see function code 24 ), 4= turn relay 2 on/off
remotely (DTMF key 7/6), then press #
Function Code 43 Do Not Disturb Time Zone
If you do not want to be disturbed from someone calling you from the system during certain hours of the days, you can
create Do Not Disturb Time Zone. For example: 22:00-06:00 Monday-Sunday. Up to 10 Do Not Disturb Time Zones ca be
programmed.
1. Log-in to programming
2. Enter 43 then #