Pach and Company Quantum QR Series QR5-QR5FF-QR5IP-QR5IPFF Manual - Manual (Page 41)

Table of Contents
file:///C|/PACH%20&%20COMPANY/PACH-CO.COM/PACH-CO.COM%202012/online_manual/qr5-qr5ip_manual.htm[5/19/2014 9:51:01 AM]
Press A, B, C or D button, red LED will be On
Extend the antenna for longer distance transmission
5.6 Extending Talk Time
The talk time timer is set on function code 27 . The warning beep will be heard one minute before the talk time is expired.
It can be extended more another full cycle by pressing #
5.7 Call the System from Premise Location
The system must be installed in Intercom and Call Forwarding Mode Wiring Diagram and also see function code 37 to
select ## or ** to initiate premise call. If ** is selected then the homeowner will not have two ways communication, see
table below
5.8 Call the System from Remote Location
1. The system must be install in Intercom and Call Forwarding Mode Wiring Diagram or Call Forwarding Mode
wiring Diagram
2. Function code 38 must be set at least for 1 ring
3. Function code 39 must be set to 1
4. You must have the system phone number
5. Call the system phone number if the system answered, short beep will be heard.
6. Press # then 4-digit Master code (default is 0000), short beep will be heard if master code is accepted
7. Press * to establish two ways communication
8. Press 9 to release relay 1 (door 1) or 8 to release relay 2 (door 2).
5.9 Call Waiting