Ransburg Vector Solo 79901 Waterborne RS90-WB - Manual (Page 20)

Vector Solo Waterborne Applicators - Installation
16
Ransburg
INSTALLATION
The following assemblies are available for
purchase:
† The air hose ground must be connected
to true earth ground.
W A R N I N G !
Interlocks Required
Interlock the solvent supply with the main supply
air to the applicator. If solvents with a flashpoint
below the normal ambient temperature of the spray
booth are used, the interlock must be installed.
When solvent is On, main supply air to the appli-
cator is Off. Interlocks are user supplied.
† The solvent supply must be interlocked
with applicator supply air.
† If solvents with a flash point below the
normal ambient temperature of the spray
booth are used, the interlock must be in-
stalled.
W A R N I N G !
79525-10 Fluid Hose Assembly, 1/4" ID X 10m long
79525-15 Fluid Hose Assembly, 1/4" ID X 15m long
79525-20 Fluid Hose Assembly, 1/4" ID X 20m long
79525-25 Fluid Hose Assembly, 1/4" ID X 25m long
79525-30 Fluid Hose Assembly, 1/4" ID X 30m long
79524-10 Fluid Hose Assembly, 3/16" ID X 10m long
79524-15 Fluid Hose Assembly, 3/16" ID X 15m long
79524-20 Fluid Hose Assembly, 3/16" ID X 20m long
79524-25 Fluid Hose Assembly, 3/16" ID X 25m long
79524-30 Fluid Hose Assembly, 3/16" ID X 30m long
WATERBORNE HOSE
ASSEMBLIES
Part # Description
In order to use a waterborne hose, the Conductive
Fluid Conversion Kit (79891-00) must be used
as well.
Figure 3: Conductive Fluid Conversion Kit
1. Ensure there is a true earth ground connection
available.
In order for the waterborne hose assembly to
work properly, it must be correctly installed onto
a current Vector Solo applicator. The following
steps describe how to install a waterborne hose
onto a Vector Solo.
Figure 4: Voltage Off Lever Position
(Bottom View)
2. Isolate the fluid source from true earth ground.
3. Ensure electrostatic On/Off lever is in the Off
position.
4. Connect the air hose ground wire to true earth
ground.
5. Connect the air hose to the applicator, thread
is left hand pitch, counter-clockwise to tighten.
AH-08-03.6
† It is the end users responsibility to insure
the ground end of the 79727-XX air hose is
connected to true earth ground.
W A R N I N G !