Ransburg Vector Solo 79901 Waterborne RS90-WB - Manual (Page 21)

Vector Solo Waterborne Applicators - Installation
17
Ransburg
6. Install the hose bracket [1] onto the fluid fitting
[2] using the bracket nut [3].
Figure 7: Waterborne Hose Assembly
7. Install the waterborne hose into the hose bracket
following these steps:
a. Remove the two (2) ferrules [7 and 8],
connector nut [6], Nylo-Seal nut [5], and
the thin jam nut [4] from the waterborne
hose [1]. Do not discard. These pieces will
be reinstalled onto the waterborne hose.
1 Waterborne Hose
2 Bulkhead Connector
3 Conductive Ferrule
4 Thin Jam Nut
5 Nylo-Seal Nut
6 Connector Nut
7 Ferrule, Front,3/8" Tube
8 Ferrule, Back, 3/8" Tube
WATERBORNE HOSE
ASSEMBLY - PARTS LIST
Part # Description
† Make sure to align the pin on the fluid
fitting [2] with the hole on the groove on
the hose bracket [1].
NOTE
Figure 8: Install Hose Into Bracket
† Make sure to align the pin on the
bulkhead connector [2] with the hole on
the hose bracket [9].
NOTE
Figure 5: Air Hose Connection
Figure 6: Install Bracket and Nut
b. Insert the waterborne hose [1], with the
conductive ferrule [3], and bulkhead
connector [2] still on the hose, through the
hole in the hose bracket [9].
6 0 % V O L T A G E 1 0 0 % V O L T A G E
C W C W
AH-08-03.6