Ransburg Vector Solo 79901 Waterborne RS90-WB - Manual (Page 37)

Vector Solo Waterborne Applicators - Maintenance
33
Ransburg
Figure 39: Second Jam Nut Replacement
3. Tighten second jam nut with raised center
facing out, while holding the needle shaft.
Figure 42: Rear Cover Replacement
4. Install the fluid adjustment assembly along with
the air and fluid return springs.
Figure 41: Fluid Hose/Trigger Installation
Figure 40: Spring and Fluid Adjust Valve Re-
placement
5. Install trigger and fluid line.
6. Reconnect the rear cover and install with two
(2) 4mm screws.
1 - Fluid Return Spring
2 - Fluid Adjustment Valve
3 - Air Valve Return Spring
AH-08-03.6