IAI America RCAW - Manual (Page 14)

8
Precautions
1. Ensure use of the product in the specified conditions, environments and ranges.
Operation out of the specified conditions could cause a drop in performance or malfunction of the product.
2. Set the allowable load of the move on rod tip within the allowable range.
An operation with the load beyond the allowable load of the move on rod tip may cause an abnormal noise,
vibration, malfunction or shortened life. If it is extreme, flaking may occur on the guide.
3. If back and forth operations are performed repeatedly in short distance, it may wear out
the film of grease.
Continuous back and forth operation within a distance less than 30mm may cause wear of grease.
As a reference, have approximately 5 cycles of back and forth operation in a distance more than 50mm in
every 5,000 to 10,000 cycles to regenerate the oil film. Keep using the actuator with the grease worn out
may cause malfunction. If it is extreme, flaking may occur on the guide.
4. Do not apply any rotation torque on the rod.
Doing so may damage the internal component such as the rod stopper, and may result in an operation
failure.