IAI America NS - Manual (Page 46)

32
8. Installation
8.2 Installation Surface
x The frame shall have sufficient structural rigidity to prevent vibration.
x The surface on which to install the actuator shall be a machined surface or a flat surface having
equivalent accuracy, where the surface flatness shall be within r0.05 mm.
x Provide the space needed to carry out maintenance work.
x The side and bottom faces of the actuator base are used as reference surfaces for slider travel
alignment.
x If high traveling accuracy is required, install the actuator using these surfaces as a reference.
As shown above, the side faces of the base are used as reference surfaces for slider travel
alignment. If high traveling accuracy is required, install the actuator using these surfaces as a
reference.
When installing the actuator on a frame using the reference surfaces of the base, provide the required
machining by following the figure below.
When machining the surface, provide a margin corresponding to the thickness of the cover to prevent the
ends of the actuator from contacting the front cover and rear cover.
Dimension A (mm)
3 to 5
Reference surface Reference surface
R0.3 max.