IAI America NS - Manual (Page 69)

55
1
1. Maintenance
When hooking the wire in step [6], you may find the wire catch of the hook (motor side) deformed. In this
case, replace the wire hook as follows:
 Replace the wire hook with a replacement wire hook (motor side), and tighten the two screws
(M3 x 6).
[7] Follow the same steps to also attach the wire to the wire hook (base side) whose screws have been
loosened. Specifically, guide the wire from the wire hook (base side) to the delrin bearing at the mid-
support, and attach it to the wire hook (motor side).
When hooking the wire in step [7], you may find the wire catch of the hook (motor side) deformed. In
this case, replace the wire in the same manner.
Tighten the screws.
Tightening torque: 1.5 (N•m)