IAI America IX-INN8040 - Manual (Page 41)

35
6. Inspection/Maintenance
6.2.5 Checking the Belt Tension for the Rotational Axis
(1) Insert a  3 pin in the hole provided on one side of arm 2 (pin length: 40 to 80 mm) until the pin lightly
contacts the belt, and then mark a point off C (mm) from the surface of arm 2.
(2) Using a push-pull gauge, push the pin with a force of D (kgf). The belt tension is normal if the mark on
the pin aligns with the surface of arm 2. If not, adjust the belt tension by referring to 6.2.7, “Adjusting
the Belt Tension for the Rotational Axis.”
Type C D
IX-HNN50/60
IX-INN50/60
2.48 (mm) 1.3 ~ 1.5 (kgf)
IX-HNN70/80
IX-INN70/80
3.60 (mm) 1.6 ~ 2.0 (kgf)
 Do not use a pin with a sharp tip that may damage the belt.
Pulley
Belt
Pulley
Arm 2
Pin
Mark here
Mark aligns with the
surface of arm 2.
C (mm)
Pulley
D (kgf)
Caution