IAI America IX-INN8040 - Manual (Page 44)

38
6. Inspection/Maintenance
(2) Perform an absolute reset for the rotational axis and vertical axis. This completes the procedure for
installation of the cover.
(Refer to 6.4, “Absolute Reset Procedure.”)
 Check the marking tubes to prevent improper connections.
 Be careful not to bend the air tubes.
 Be careful not to let the cables contact the pulley.
 Check if the connectors are fully inserted.
 Be careful not to pinch the cables.
 Perform an absolute reset for the rotational axis and vertical axis only after adjustment of the belt
tension.
[3] 4 - M3 x 10
M cable
Installation position
of M connector
U cables
Installation
position of U
connectors
Be careful not to let them
contact the pulley.
Caution