IDEC SX5L Series - Manual (Page 17)

2: H ARDWARE S PECIFICATIONS
2-6 SX5L C OMMUNICATION T ERMINAL U SER ’ S M ANUAL
Digital Output Modules SX5L-SBT16K1 / SX5L-SBT16S1
General Specifications
Transistor Output Specifications
Rated Power Voltage 24V DC
Power Voltage Range 21.6 to 26.4V DC (including 5% ripple)
Power Consumption 1.2W (24V DC)
Power Inrush Current 3A maximum (24V DC)
Allowable Momentary Power Interruption 10 ms minimum (at the rated power voltage)
Dielectric Strength 1,000V AC, 1 minute between power and FG terminals
Insulation Resistance 100 M Ω minimum between power and FG terminals (500V DC megger)
Operating Temperature 0 to 55°C (no freezing)
Operating Humidity 30 to 90% RH (non-condensing)
Storage Temperature –20 to +75°C (no freezing)
Storage Humidity 30 to 90% RH (non-condensing)
Pollution Degree 2 (IEC 60664)
Corrosion Immunity Atmosphere free from corrosive gases
Altitude
Operation: 0 to 2,000m
Transpor t: 0 to 3,000m
Vibration Resistance
10 to 57 Hz amplitude 0.075 mm, 57 to 150 Hz acceleration 9.8 m/s 2
2 hours per axis on each of three mutually perpendicular axes
Shock Resistance 294 m/s 2 , 11-ms sinusoidal half-wave pulse
Mounting 35-mm-wide DIN rail, direct panel mounting (M4 mounting screws)
Weight (approx.) 240g
Type No. SX5L-SBT16K1 SX5L-SBT16S1
Output Points 16 points
Output Type N-MOS open drain (NPN transistor output) P-MOS open drain (PNP transistor output)
Rated Load Voltage 24V DC
Load Voltage Range 21.6 to 26.4V DC
Maximum Load Current
500 mA per point
6A per common line
Output Common Polarity Plus common Minus common
Voltage Drop (ON Voltage)
0.8V maximum
(voltage between the power – terminal and
output terminals when output is on) 0.8V maximum
(voltage between the power + terminal and
output terminals when output is on)
Leakage Current 1 mA maximum
Isolation from Power Line Photocoupler isolation
Dielectric Strength
500V AC, 1 minute between output and FG terminals
500V AC, 1 minute between output and power terminals
Insulation Resistance
100 M Ω minimum between output and FG terminals (500V DC megger)
100 M Ω minimum between output and power terminals (500V DC megger)