IDEC SX5L Series - Manual (Page 32)

SX5L C OMMUNICATION T ERMINAL U SER ’ S M ANUAL 3-1
3: I
NSTALLATION AND
W
IRING
Introduction
This chapter describes the methods and precautions for installing and wiring the SX5L communication terminals.
Before starting installation and wiring, be sure to read “Safety Precautions” in the beginning of this manual and under-
stand precautions described under Warning and Caution.
Mounting on DIN Rail
1. Fasten the DIN rail to a panel using screws firmly.
2. Pull out the clamp from the SX5L module, and put
the groove of the module on the DIN rail. Press the
module towards the DIN rail and push in the clamp as
shown on the right.
3. Use BNL6P mounting clips on both sides of the
SX5L module to prevent moving sideways.
Removing from DIN Rail
1. Insert a flat screwdriver into the slot in the clamp.
2. Pull out the clamp from the SX5L module.
3. Turn the SX5L module bottom out.
Mounting on Panel
The SX5L modules can also be mounted directly on a panel surface using M4 mounting screws. For the mounting hole
layout, see page 2-2.
Warning
• Turn off the power to the SX5L before mounting and removing. Failure to turn power off may
cause electrical shocks or fire hazard.
Caution
• Install the SX5L modules according to instructions described in this user’s manual. Improper
installation will result in falling, failure, or malfunction of the SX5L.
• Mount the SX5L modules on a 35-mm-wide DIN rail or a panel surface.
Applicable DIN rail: IDEC’s BAA1000NP or BAP1000NP (1000mm/39.4” long)
Press
Groove
35-mm-wide DIN Rail
Clamp
Pull out
35-mm-wide DIN Rail
Clamp